User`s manual

B-2

SUPERSERVER 2016Ti-HTRF User's Manual

When the Boot Sector Recovery Process is complete, the system will reboot 5.

automatically and you will see a checksum error on your screen.

Part 2: BIOS Reprogramming (Re-Flashing)

After completing the Boot Sector Recovery Process, you will need to reprogram

(“re-ﬂ ash”) the proper BIOS binary ﬁ le again into the BIOS ROM in order to have

the correct BIOS ﬁ le loaded by the system. For details on how to ﬂ ash/re-ﬂ ash a

BIOS, please check our website for “Update your BIOS”, or see the section 3-3

(FAQ) of this manual. DO NOT INTERRUPT THIS PROCESS!

When completed, the system will reboot automatically, and you will see a checksum

error again.

Press “F1” to go to setup. Press “F9” to load the defaults and then press “F10” to

save and exit.

B-2 Recovery from an IDE/SATA ATAPI Drive

This process is identical to the Boot Sector Recovery Process from a USB Device/

Drive (as above), except that the BIOS image ﬁ le (“super.rom”) is loaded from an

IDE/ATAPI CD/DVD/ROM/RW disc drive that is attached to the system. Note that

loading from an IDE/SATA hard disk drive is NOT supported.

Using a different system, download and copy the correct BIOS binary image 1.

into a writable CD/DVD disc's Root "\" Directory. Rename the downloaded

ﬁ le to "super.rom", so the recovery process can recognize and read the BIOS

binary ﬁ le.

Note: Record/Burn the CD/DVD-R/RW disc using the ISO 9600 standard for-

mat. Refer to your CD/DVD mastering application documentation for instruc-

tions on how to do this.

Insert the newly-created disc into the IDE/SATA ATAPI CD/DVD ROM/RW 2.

drive of the system that has the corrupted BIOS and power the system down.

Follow the step-by-step instructions under Part 1 - Recovery Process from a 3.

USB Device/Drive (above) starting from Step 3 and continue on to Part 2 -

BIOS Reprogramming (Re-Flashing).

If your system still does not boot up after performing the above procedure, then

there may be other issues with your motherboard. Please contact your customer

service representative.