User`s manual

SC812L Chassis Manual
4-6
Add-on Card/Expansion Slot Setup
SC812L chassis includes I/O slots for add-on cards and expansion cards. The
number of cards you can use depends on your chassis model.
SC812L chassis includes one full length/full height and one low profi le add-on card
slot. SC812L models "C" models include one full length/full height slot.
SC812L "U" models include two full height/full length add-on card slots and one
low-profi le slot.
Figure 4-5: SC812L Add-on Card
To install an add-on card:
1. Disconnect the power supply, lay the chassis on a fl at surface, and open the
chassis cover.
2. In the rear of the chassis, pull open the add-on card clip and remove the add-
on card shield.
3. If you have not already done so, remove the Riser Card Bracket. To do so,
simple remove the screws and life the Riser Card Bracket straight up. De-
pending on your chassis model, you must remove two or three screws.
Low Profi le Add-on
Card Slot
Full Length/Full Height
Add-on Card Slot
Riser Card Bracket
Add-on Card
Shield