User`s guide

4-6
AOC-USASLP-H8iR Add-on Card User's Guide
connecttoaremoteserverunlessyoursteditthestartupui.batle.Specically,you
mustaddtheIPaddressoftheremoteservertotheendofthestartupui.batle.
For example, to connect to a remote framework on server 192.168.0.10, add the IP
address to the end of startupui.bat as shown in this example: start JRE\bin\javaw
-classpath .;GUI.jar GUI.VivaldiStartupDialog ajsgyqkj=71244 192.168.0.10
Be sure to include a space in front of the IP address, as shown in the example.
Installing MegaRAID Storage Manager Software for Linux
Follow these steps if you need to install MegaRAID Storage Manager software on
a system running Red Hat Linux or SUSE Linux:
Installing MegaRAID Storage Manager
CopytheSSM_linux_installer...tar.gzletoatemporaryfolder.1.
UntartheSSM_linux_installer...tar.gzleusingthefollowingcommand: 2.
tar -zxvf SSM_linux_installer...tar.gz
A new disk directory is created.
Go to the new disk directory.3.
Inthediskdirectory,ndandreadthereadme.txtle.4.
To start the installation, enter the following command: 5.
./install.sh
If you select Client installation for a PC used to monitor servers, and if there are no
available servers with a registered framework on the local subnet (that is, servers
with a complete installation of MegaRAID Storage Manager software), you cannot
connecttoaremoteserverunlessyoursteditthestartupui.shle.Specically,you
mustaddtheIPaddressoftheremoteservertotheendofthestartupui.shle.
For example, to connect to a remote framework on server 192.168.0.10, add the
IP address to startupui.sh as shown in this example:
Start JRE\bin\javaw -classpath .;GUI.jar GUI.VivaldiStartupDialog ajsgyqkj=71244
192.168.0.10
Be sure to include a space in front of the IP address, as shown in the example.