User`s manual

6-7
Chapter 6: Using the Configuration Utility
Device is a Hard disk
Enclosure # : 2
Slot # : 1
Connector ID : 4
State : Ready (RDY)
Size (in MB)/(in sectors) : 70007/143374738
Manufacturer : HP
Model Number : DG072A9BB7
Firmware Revision : HPD0
Serial No : B365P720H7L70709
Protocol : SAS
Drive Type : SAS
------------------------------------------------------------
Enclosure information
------------------------------------------------------------
Enclosure# : 1
Logical ID : 51234567:89012345
Numslots : 8
StartSlot : 0
Values
Logical drive status values are as follows:
• Okay (OKY) – The volume is Active and drives are functioning properly. User data
is protected if the current RAID level provides data protection.
• Degraded (DGD) – The volume is Active. User data is not fully protected due to a
configuration change or drive failure.
• Failed (FLD) – The volume has failed.
• Missing (MIS) – The volume is missing.
• Initializing (INIT) – The volume is initializing.
• Online (ONL) – The volume is online.
Physical device status values are as follows:
• Online (ONL) – The drive is operational and is part of a logical drive.
• Hot Spare (HSP) – The drive is a hot spare that is available to replace a failed
drive in an array.
• Ready (RDY) – The drive is ready for use as a normal disk drive, or it is ready to
be assigned to a disk array or a hot spare pool.
• Available (AVL) – The drive may or may not be ready, and it is not suitable for
use in an array or a hot spare pool.
• Failed (FLD) – The drive was part of a logical drive or was a hot spare drive, and
it failed. The drive is now offline.