User`s manual

6-11
Chapter 6: Using the Configuration Utility
Parameters
None
Program Return Value
0x00 SUCCESS: Command completed successfully.
0x01 FAILURE: Command failed.
0x02 ADAPTER_NOT_FOUND: Cannot find specified adapter.
Sample Output
Here is an example of the output of the LIST command. The format and fields in the
output may vary depending on the types of installed controllers.
MFGPAGE Command
The MFGPAGE command updates information on manufacturing pages. Only DOS and
EFI support this command.
Command Line
sas2ircu <controller #> mfgpage <passcode> <mfgpage #>
<offset> <value>
Parameters
• <controller #> – The index of the controller with the manufacturing pages you want
to update.
• <passcode> – A passcode is required for DOS access, which is restricted.
• <mfgpage #> – The manufacturing page (4 or 10) that needs to be updated.
• <offset> – The dword offset in the specified manufacturing page that needs to be
updated, in hex format.
• <value> – The value for the offset that is being modified, in hex format.
Program Return Value
0x00 SUCCESS: Command completed successfully.
0x01 FAILURE: Bad command-line arguments or operational failure.
0x02 ADAPTER_NOT_FOUND: Cannot find specified adapter.
Index
Adapter
Type
Vendor
ID
Device
ID
PCI Address
SubSys
Ven ID
SubSys
Dev ID
0 SAS2008 1000h 72h 00h:01h:00h:00h 1000h 00dah
1 SAS2008 1000h 72h 00h:05h:00h:00h 1000h 00dah