User`s manual

AOC-USAS2-L8i/L8e Add-on Card User’s Manual
7-10
7-4 Creating a RAID 0 Volume
Follow these steps to create a RAID 0 volume with the SAS2 BIOS Configuration Utility.
1. On the A
DAPTER LIST screen, use the arrow keys to select a SAS adapter and then
press E
NTER.
The ADAPTER PROPERTIES screen appears (see Figure 7-2).
2. Use the arrow keys to select RAID PROPERTIES, and then press ENTER.
The SELECT NEW VOLUME TYPE screen appears (see Figure 7-3).
3. Select CREATE RAID 0 VOLUME.
The CREATE NEW VOLUME screen appears (Figure 7-7).
4. Move the cursor to the RAID D
ISK column and select a line that has a No entry in
this column, indicating that the disk is not already part of the volume being created.
To add the disk to the new volume, change the N
O to Yes by pressing the space bar.
5. Move the cursor to another line and press the space bar to add another disk to the
volume.
NOTE: See the instructions in Section : "Creating Hot Spare Disks" on
page 7-15, if you want to create one or two global hot spares.
Figure 7-9. Create New Volume Screen – RAID 10