User`s guide

2-8

SC512 Chassis User’s Guide

E. Installing the Motherboard

Be sure to disconnect the power supply before accessing or installing the motherboard

into the chassis. (Refer to Chapter 1 for Safety Guidelines.)

Procedures

1. Lay the chassis on a ﬂ at surface.

2. Locate the CPU location(s). If you have a UP system, be sure to install heatsink

brackets on the reverse side of the CPU. (Ignore this step if you have a DP sys-

tem.)

3. Lay the motherboard on the standoffs and secure it (with Mylar sheets, if any)

to the chassis with type A screws.

4. Secure CPU heatsink(s) to the motherboard. (*Refer to the next section for

heatsink installation.)

5. Install the air shroud(s) on the motherboard by inserting air shroud clips into the

corresponding holes.

(**Note: the CPU, heatsinks and the motherboard shown above are for refer-

ence only!! Both items are not included in the SC512 shipping package.)

Standoffs