User`s manual

B-5
:
82h
The keyboard controller interface test completed. Writing the command byte and
initializing the circular buffer next.
83h
The command byte was written and global data initialization has completed.
Checking for a locked key next.
84h
Locked key checking is over. Checking for a memory size mismatch with CMOS
RAM data next.
85h
The memory size check is done. Displaying a soft error and checking for a
password or bypassing WINBIOS Setup next.
86h
The password was checked. Performing any required programming before
WINBIOS Setup next.
87h
The programming before WINBIOS Setup has completed. Uncompressing the
WINBIOS Setup code and executing the AMIBIOS Setup or WINBIOS Setup
utility next.
88h
Returned from WINBIOS Setup and cleared the screen. Performing any
necessary programming after WINBIOS Setup next.
89h
The programming after WINBIOS Setup has completed. Displaying the power on
screen message next.
8Ch Programming the WINBIOS Setup options next.
8Dh
The WINBIOS Setup options are programmed. Resetting the hard disk controller
next.
8Fh
The hard disk controller has been reset. Configuring the floppy drive controller
next.
91h
The floppy drive controller has been configured. Configuring the hard disk drive
controller next.
95h
Initializing the bus option ROMs from C800 next. See the last page of this
chapter for additional information.
96h Initializing before passing control to the adaptor ROM at C800.
97h
Initialization before the C800 adaptor ROM gains control has completed. The
adaptor ROM check is next.
98h
The adaptor ROM had control and has now returned control to BIOS POST.
Performing any required processing after the option ROM returned control.
99h
Any initialization required after the option ROM test has completed. Configuring
the timer data area and printer base address next.
9Ah Set the timer and printer base addresses. Setting the RS-232 base address next.
9Bh
Returned after setting the RS-232 base address. Performing any required
initialization before the Coprocessor test next.
9Ch
Required initialization before the Coprocessor test is over. Initializing the
Coprocessor next.
9Dh
Coprocessor initialized. Performing any required initialization after the
Coprocessor test next.
9Eh
Initialization after the Coprocessor test is complete. Checking the extended
keyboard, keyboard ID, and Num Lock key next. Issuing the keyboard ID
command next.
A2h Displaying any soft errors next.
Checkpoint Code Description