User`s manual

Chapter 2: Installation
2-5
Figure 2-1. Side and Top Views of DDR Installation
To Install:
Insert module vertically
and press down until it
snaps into place. The
release tabs should
close - if they do not
you should close them
yourself.
To Remove:
Use your thumbs to
gently push each
release tab outward to
release the DIMM from
the slot.
Note: Notch
should align
with its
receptive point
on the slot
Notch
Notch
Release
Tab
Release
Tab
Note the notch in the slot and on the bottom of the DIMM.
These prevent the DIMM from being installed incorrectly.
Gently press down on the memory module until it snaps into place.3.
With four CPUs installed, repeat step 2 to populate the CPU2 DIMM slots. Al-4.
ways install four DIMMs to both CPU DIMM slots for more effi cient operation.
Note: 1 GB, 2 GB, 4 GB, 8 GB and 16 GB memory modules are supported. It
is highly recommended that you remove the power cord from the system before
installing or changing memory modules. Please refer to our web site for memory
that has been tested on the H8QG6/i+-F serverboard.
Memory Support
The H8QG6/i+-F serverboard supports single/dual/tri/quad-channel, DDR3-
1333/1066/800 registered ECC/Unbuffered ECC/non-ECC SDRAM. Only
interleaved memory is supported, so you must populate four DIMM slots at a time
(see procedure above).
Populating four adjacent slots at a time with memory modules of the same size and
type will result in interleaved (128-bit) memory, which is faster than non-interleaved
(64-bit) memory.
Maximum Memory
The H8QG6/i+-F serverboard supports up to 512 GB of DDR3-1333/1066/800
registered ECC or 128GB of DDR3 Unbuffered ECC/non-ECC SDRAM.