User`s manual

Chapter 1: Introduction
1-5
X8DT6/E-F Quick Reference
Jumper Description Default Setting
JBT1 CMOS Clear (See Section 2-7)
JI
2
C1/JI
2
C2 SMB to PCI Slots 2-3 (Disabled)
JPG1 VGA Enable Pins 1-2 (Enabled)
JPL1/JPL2 LAN Ports 1/2 Enable Pins 1-2 (Enabled) (For a Rev. 1.31 or later board)
JPS1 SAS Enable Pins 1-2 (Enabled) (X8DT6/X8DT6-F)
JWD Watch Dog Pins 1-2 (Reset)
Connector Description
COM1/COM2 COM1/COM2 Serial Port/Header
FAN 1-8 System/CPU Fan Headers (Fans 7~8: CPU Fans)
Floppy Floppy Disk Drive Connector
JIBTN1 RAIDKey for RAID 5 SAS support (optional for X8DT6/X8DT6-F)
J5 IPMB I
2
C Header (for an IPMI card) (X8DTE-F/X8DT6-F)
JD1 PWR LED/Speaker Header (Pins 4~7: Speaker)
JF1 Front Panel Connector
JL1 Chassis Intrusion Header
JOH1 Overheat LED Header
JPIC
2
1 Power Supply SMBbus I
2
C Header
JPW1 24-pin ATX Main Power Connector (Warning on Pg. 1-4)
JPW2, JPW3 8-pin Secondary Power Connector (Warning on Pg. 1-4)
JWF1 DOM (Disks_On_Module) Power Header
JWOL Wake-On-LAN Header
LAN1/2, IPMI_LAN Gigabit Ethernet (RJ45) Ports 1/2 & IPMI_Dedicated LAN
(
IPMI_LAN is for X8DTE-F/ X8DT6-F only)
I-SATA0 ~ I-SATA5 (Intel South Bridge) SATA Ports
SAS 0~3, 4~7 SAS Ports 0~3, 4~7 (X8DT6/X8DT6-F only)
SP1 Internal Speaker/Buzzer
TPM TPM (Trusted_Platform_Module) Header
T-SGPIO-1/T-SGPIO-2 Serial General Purpose Input/Output Headers
USB 0/1, 2,3, 4/5, 6/7 Universal Serial Bus (USB) Ports
VGA VGA Connector
LED Description
D1 BMC Heartbeat LED Indicator (X8DTE-F/X8DT6-F only)
LE1 Onboard Standby LED Indicator
LED1 SAS LEDs (LED1: SAS Heartbeat LED) (X8DT6/X8DT6-F only)
Note: Jumpers JPL1/JPL2 are available for the PCB Rev. 1.31 or a later vision of
motherboard only.