Datasheet

Chapter 1: Introduction
1-7
Motherboard Features
CPU ! Latest CPU technology!
Single Pentium
®
4 478-pin PGA processors or Intel Celeron processors
up to up to 3.40 GHz (at a 800/533/400 MHz FSB) w/HyperThreading.
Intel Pentium 4/Celeron processors (*use 0.09 or 0.13 Micron Manufac-
turing Technology CPUs)
Note: Refer to the motherboard specifications pages on our web site (http://
www.supermicro.com/Product_page/product-m.htm) for updates on supported processors.
Memory
!!
!!
! Latest memory technology!
Dual Channel DDR up to 4 GB ECC, non-ECC, unbuffered DDR-400/333/
266 SDRAM in 2 Banks 4 DIMMs (*For Dual-Channel operation, identical
pair(s) of memory modules must be populated in DIMM0A, DIMM1A and/or
DIMM0B, DIMM1B.). (*See Section 2-4 for more details)
Intel Performance Acceleration Technology!
(*Note: The Canterwood chip supports non-ECC or ECC memory. If ECC
memory is installed, the ECC bits need to be initialized via BIOS before normal
operation. For a 4 GB-Memory and 2.4-GHz P4 system, it will take about 65
seconds for all the ECC bits to be initialized before any video displays. Since
ECC initialization takes time, the Watch Dog Timer Select needs to be set to a
time longer than what the ECC initialization will take.)
Chipset ! Latest Intel chipset technology!
Intel 875P Canterwood (*P4SCT/P4SCT+II)
Intel E7210 Canterwood ES (*P4SCT+)
Expansion Slots
Three 64-bit, 66 MHz PCI-X slots (3.3 V)
Two 32-bit, 33 MHz PCI slots (5 V)
BIOS
8 Mb Firmware Hub AwardBIOS
®
Flash BIOS
APM 1.2, DMI 2.3, PCI 2.3, ACPI 1.0, Plug and Play (PnP)
PC Health Monitoring
Eight onboard voltage monitors for CPU core, +3.3V, +3.3V standby,
+5V, +5V standby, Vbat (battery voltage) and ±12V
Fan status monitor with firmware/software on/off control
Supero Doctor III, Watch Dog, NMI
Environmental temperature monitoring and control
Power-up mode control for recovery from AC power loss
System overheat LED and control
System resource alert
Hardware BIOS virus protection
Auto-switching voltage regulator for the CPU core