Datasheet

1-12
PDSM4+/PDSME+ User’s Manual
Main Switch Override Mechanism
When an ATX power supply is used, the power button can function as a system
suspend button to make the system enter a SoftOff state. The monitor will be
suspended and the hard drive will spin down. Pressing the power button again
to "wake-up" the whole system. During the SoftOff state, the ATX power supply
provides power to keep the required circuitry in the system alive. In case the
system malfunctions and you want to turn off the power, just press and hold the
power button for 4 seconds. This option can be set in the Power section of the
BIOS Setup routine.
External Modem Ring-On
Wake-up events can be triggered by a device such as the external modem ringing
when the system is in the SoftOff state. Note that external modem ring-on can only
be used with an ATX 2.01 (or above) compliant power supply.
Wake-On-LAN (WOL)
Wake-On-LAN is defi ned as the ability of a management application to remotely
power up a computer that is powered off. Remote PC setup, up-dates and asset
tracking can occur after hours and on weekends so that daily LAN traffi c is kept to
a minimum and users are not interrupted. The motherboard has a 3-pin header
(WOL) to connect to the 3-pin header on a Network Interface Card (NIC) that has
WOL capability. In addition, an onboard LAN controller can also support WOL
without any connection to the WOL header. The 3-pin WOL header is to be used
with a LAN add-on card only.
*Note: Wake-On-LAN requires an ATX 2.01 (or above) compliant power supply.
1-6 Power Supply
As with all computer products, a stable power source is necessary for proper and
reliable operation. It is even more important for processors that have high CPU
clock rates.
The PDSM4+/PDSME+ can only accommodate 24-pin ATX power supplies. Al-
though most power supplies generally meet the specifi cations required by the CPU,
some are inadequate. In addition, the 12V 8-pin power connection is also required
to ensure adequate power supply to the system. Also your power supply must
supply 1.5A for the Ethernet ports. It is strongly recommended that you use a high
quality power supply that meets ATX power supply Specifi cation 2.01 or above. It
must also be SSI compliant (info at http://www.ssiforum.org/). Additionally, in areas
where noisy power transmission is present, you may choose to install a line fi lter to
shield the computer from noise. It is recommended that you also install a power
surge protector to help avoid problems caused by power surges.