User's Manual (1.0a)

SBI-7128R-C6/C6N Blade Module User’s Manual
1-2
1-3 Blade Module Features
Table 1-1 lists the main features of the SBI-7128R-C6/C6N blade module. See the
proceeding section for components typically included in a blade system and other
optional components. Specific details for the SBI-7128R-C6/C6N blade module are
found in Chapter 4: "Blade Module Features" on page 4-1.
Processors
The SBI-7128R-C6/C6N blade module supports dual 2011-pin (LGA 2011 Socket R3)
Intel Xeon E5-2600 v3 series processors.
Refer to the Supermicro web site for a complete listing of supported processors (http://
www.supermicro.com/products/superblade). Please note that you will need to check the
detailed specifications of a particular blade module for a list of the CPUs it supports.
Details on installation of the processor into the SBI-7128R-C6/C6N blade module are
found in Chapter 3: "Setup and Installation" on page 3-1.
Memory
The SBI-7128R-C6/C6N blade module has sixteen (16) 288-pin DDR4 DIMM sockets
that can support up to either 512 GB of 64 GB and 32 GB LRDIMM or 1 TB of 32 GB, 16
GB, 8 GB and 4 GB RDIMM, 2133/1866/1600 MHz speed SDRAM. Memory is
interleaved, which requires modules of the same size and speed to be installed in
groups (of two or three).
Table 1-1. SBI-7128R-C6/C6N Blade Module Specification Features
Mainboard
B10DRC (proprietary form factor)
Chassis Dimensions (HxWxD): 11.32"x 1.67" x20.5" (288-mm x 42.4-mm x
520.7-mm)
Processors
Dual or quad core Intel
™
Xeon
®
E5-2600 v3 series 2011-pin processors.
Please refer to our web site for a complete listing of supported processors.
FSB Speed QPI up to 9.6 GT/s
Chipset Intel C612
Graphics Controller Aspeed AST2400 BMC Graphics
BIOS 128 MB SPI Flash EEPROM with AMI® BIOS
Memory Capacity
Supports up to 1 TB memory in 64 GB and 32 GB LRDIMM or 512 GB in
32 GB, 16 GB, 8 GB and 4 GB RDIMM size, 2133/1866/1600 MHz speed
SDRAM in sixteen (16) 288-pin DDR4 DIMM sockets
SATA Controller Intel C612 on-chip controller for six Serial ATA drives
Hard Drive Bays
Includes six hot-swap drive bays for 2.5" Hot-swap HDD/SSD/NVMe SATA
disk drives (RAID 0, 1 and 5), but only three of these drives can support
NVMe.