User`s manual

Superblade Network Modules User’s Manual
7-30
Table 7-13. IP Extended ACL Configuration Page Parameters
Parameter Description
ACL Number
This parameter specifies the unique ID for the access list. This value must
be in the range from 1001 to 65535.
Action
This parameter specifies whether the packets must be allowed or dropped
when a match has been found.
Source and Destination IP
Address
This parameter specifies the IP Address for which the access list must be
applied.
Subnet Mask
This parameter specifies the Address Mask corresponding to the IP
Address.
Ports List (Incoming)
This parameter specifies the Incoming Port List for which the filter has to
be applied.
Ports List (Outgoing)
This parameter specifies the Outgoing Port List for which the filter has to
be applied.
Protocol This parameter specifies the type of protocol.
Message Code
This parameter specifies the Message Code to be checked for ICMP
Packets.
Message Type
This parameter specifies the Message Type to be checked for ICMP
Packets.
Priority This parameter specifies the Priority for the filter.
TOS This parameter specifies the Type of Service for the access list.
ACK Bit
This parameter indicates the TCP Ack Bit to be checked against the
incoming packet.
RST Bit
This parameter indicates the TCP Reset Bit to be checked against the
incoming packet.
Source Port (Min)
These parameters specify the range of TCP/UDP sourceports from which
the access list must be applied.
Source Port (Max)
Destination Port (Min)
These parameters specify the destination ports to which the access list
must be applied
Destination Port (Max)