User`s manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 System Safety
- Chapter 3 Setup and Installation
- Chapter 4 InfiniBand Modules
- Chapter 5 Ethernet Modules
- 5-1 SBM-GEM-001 Gigabit Ethernet Switch Module
- 5-2 SBM-GEM-X2C(+) 1/10-Gb Ethernet Switch Module
- 5-3 SBM-GEM-X3S+ 1/10-Gb Ethernet Switch Module
- 5-4 SBM-GEM-002 1-Gb Ethernet Pass-through Module
- 5-5 SBM-XEM-002/M 10-Gb Ethernet Pass-through Module
- 5-6 SBM-GEP-T20 1-Gb Ethernet Pass-through Module for Twin-Blade Modules
- 5-7 SBM-XEM-X10SM 10-Gb Ethernet Switch Module
- Chapter 6 1-Gb Ethernet Switch Firmware
- Chapter 7 Layer 2/3 Ethernet Switch Firmware
- 7-1 Overview
- 7-2 Login
- 7-3 Home Page
- 7-4 System Management Page
- 7-5 Layer 2 Management
- 7-6 Layer 3 Management
- 7-7 Multicast
- 7-8 Statistics
- Appendix A HCA Mezzanine Cards
- Appendix B LED Descriptions
- Appendix C Installing Triple Wide Bays
Superblade Network Modules User’s Manual
7-134
Interface
Clicking the INTERFACE tab brings up the OSPF INTERFACE CONFIGURATION page
(Figure 7-119). The parameters for this page are shown in Table 7-92.
Figure 7-119. OSPF Interface Configuration Page
Table 7-92. OSPF Interface Configuration Page Parameters
Parameter Description
Interface This parameter specifies the interface index of the port.
Area ID
This parameter indicates the 32-bit integer uniquely identifying the area to
which the interface connects.
Priority
This parameter specifies the priority of this interface, which is used in the
DR election algorithm.
Authentication Type
This parameter allows you to choose MD5, Simple Password or None as
the authentication type.
MD5 Key ID
This parameter specifies the secret key used to create the message digest
appended to the OSPF packet, if the authentication type is MD5.
Authentication Key
This parameter specifies the key required for authentication, if
authentication is enabled on this interface.
IP Address This parameter specifies the IP Address of the OSPF interface.