User`s manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 System Safety
- Chapter 3 Setup and Installation
- Chapter 4 InfiniBand Modules
- Chapter 5 Ethernet Modules
- 5-1 SBM-GEM-001 Gigabit Ethernet Switch Module
- 5-2 SBM-GEM-X2C(+) 1/10-Gb Ethernet Switch Module
- 5-3 SBM-GEM-X3S+ 1/10-Gb Ethernet Switch Module
- 5-4 SBM-GEM-002 1-Gb Ethernet Pass-through Module
- 5-5 SBM-XEM-002/M 10-Gb Ethernet Pass-through Module
- 5-6 SBM-GEP-T20 1-Gb Ethernet Pass-through Module for Twin-Blade Modules
- 5-7 SBM-XEM-X10SM 10-Gb Ethernet Switch Module
- Chapter 6 1-Gb Ethernet Switch Firmware
- Chapter 7 Layer 2/3 Ethernet Switch Firmware
- 7-1 Overview
- 7-2 Login
- 7-3 Home Page
- 7-4 System Management Page
- 7-5 Layer 2 Management
- 7-6 Layer 3 Management
- 7-7 Multicast
- 7-8 Statistics
- Appendix A HCA Mezzanine Cards
- Appendix B LED Descriptions
- Appendix C Installing Triple Wide Bays
7-151
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Clicking the LOCAL PREF tab brings up the BGP LOCAL PREFERENCE CONFIGURATION
page (Figure 7-132), which allows you to configure the Local Preference value for
routes. The parameters for this page are shown in Table 7-105.
Table 7-105. BGP Local Preference Configuration Page Parameters
Parameter Description
Local Preference ID
This parameter specifies the Local Preference ID, which is the index for
this table.
Remote AS
This parameter specifies the AS number from which the route update is
received.
IP Address Prefix
This parameter specifies the IP Address prefix for which the update is
received.
IP Address Prefix Length This parameter is used to calculate the subnet.
Intermediate AS This parameter represents the intermediate AS between the BGP peers.
Direction
This parameter can be set for the incoming or the outgoing packets using
In and Out values.
Value
This parameter specifies the Local preference value to be associated with
this learnt path.
Preference This parameter is used to enable/disable filtering.
Status This parameter specifies the status of the entry.