User`s manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 System Safety
- Chapter 3 Setup and Installation
- Chapter 4 InfiniBand Modules
- Chapter 5 Ethernet Modules
- 5-1 SBM-GEM-001 Gigabit Ethernet Switch Module
- 5-2 SBM-GEM-X2C(+) 1/10-Gb Ethernet Switch Module
- 5-3 SBM-GEM-X3S+ 1/10-Gb Ethernet Switch Module
- 5-4 SBM-GEM-002 1-Gb Ethernet Pass-through Module
- 5-5 SBM-XEM-002/M 10-Gb Ethernet Pass-through Module
- 5-6 SBM-GEP-T20 1-Gb Ethernet Pass-through Module for Twin-Blade Modules
- 5-7 SBM-XEM-X10SM 10-Gb Ethernet Switch Module
- Chapter 6 1-Gb Ethernet Switch Firmware
- Chapter 7 Layer 2/3 Ethernet Switch Firmware
- 7-1 Overview
- 7-2 Login
- 7-3 Home Page
- 7-4 System Management Page
- 7-5 Layer 2 Management
- 7-6 Layer 3 Management
- 7-7 Multicast
- 7-8 Statistics
- Appendix A HCA Mezzanine Cards
- Appendix B LED Descriptions
- Appendix C Installing Triple Wide Bays
5-5
Chapter 5: Ethernet Modules
5-3 SBM-GEM-X3S+ 1/10-Gb Ethernet Switch Module
The SBM-GEM-X3S+ 1/10-Gigabit Ethernet switch module is a layer 2/3 Ethernet
switch. It includes three 10-Gb/s uplink ports (SFP+), four 1-Gb/s uplink RJ45 uplink
ports and twenty 1-Gb/s downlink ports for the SuperBlade's LAN interfaces. The
Ethernet switch module has two internal Ethernet paths to the CMM(s). The switch is
used to provide a connection between the Ethernet controller integrated on the
mainboard and an external Ethernet device. This is a hot-pluggable module. See
Figure 5-3, Table 5-7 and Table 5-8 for switch details.
Figure 5-3. SBM-GEM-X3S+ 1/10-Gigabit Ethernet Switch Module Ports & Indicators
Table 5-7. SBM-GEM-X3S+ 1/10-Gigabit Ethernet Switch Module Interface
Item Description
1 RS-232 (COM) Serial Port
2 Module Fault LED
3 “Initiation OK” LED
4 SFP+ 10-Gbps Uplink Ports
5 10-Gbps Uplink Port Status LEDs (3)
6 1-Gbps RJ45 Uplink Ports (4)
7 1-Gbps RJ45 Uplink Port Status LEDs (Link/Activity and Speed)
8 Module Release Handle
23
1
7
4
5
6
8