User's Manual (1.0d)

5-5
Chapter 5 Chassis Setup and Maintenance
5-5 DVD-ROM Drive Installation
Some SC113 chassis models include a DVD-ROM, which is usually pre-installed.
Installing or Replacing a DVD-ROM Drive
1. Power down the system as described in Section 5-2 and if necessary, remove the
server from the rack and pull the mini-bezel (grate) from the DVD-ROM drive bay.
2. Remove the chassis cover.
3. Unplug the drives power and data cables from the motherboard and/or back-
plane.
4. Unlock the mini-bezel lock scew and remove the mini-bezel from the drive bay.
The bezel can be removed by pulling out the hard drive beneath the DVD-ROM,
then pulling the mini-bezel forward.
5. When installing or removing a DVD-ROM drive, the mini-bezel lock screw must
be removed and the drive tray must be completely seperated from the chassis.
6. Remove the DVD-ROM from the drive tray by removing the drive screws, then
secure the replacement DVD-ROM into the drive tray, using the drive screws.
7. Reattach the drive tray to the chassis by replacing the mini-bezel lock screw,
and tightening it from inside the chassis.
8. Reconnect the data and power cables.
9. Replace the chassis cover and power up the system.
Figure 5-4. Installing the DVD-ROM Drive
Mini-Bezel
Lock Screw
Drive
Screw
Drive
Screws