User's Manual (1.0)
Chapter 5: Advanced Serverboard Setup
5-13
Power Button Connector
The PW_ON connector is on pins 1 and 2
of JF1. Momentarily contacting both pins
will power on/off the system. This button
can also be congured to function as a
suspend button (with a setting in the BIOS,
see Chapter 7). To turn off the power when
set to suspend mode, press the button for
at least 4 seconds. Refer to the table on
the right for pin denitions.
This header should be connected to the
chassis power button.
5-7 Connector Denitions
Power Button
Pin Denitions
(JF1)
Pin# Denition
1 Signal
2 Ground
Power Connectors
The X10DRG-H/HT serverboard has one proprietary main power (JPW1) and six
8-pin 12V power connectors (JPW2, JPW3/JPW4/JPW5/JPW6/JPW7). The 8-pin
power connector located at JPW2 is used to supply power to the serverboard, and
the other ve 8-pin power connectors located at JPW3-JPW7 are used for HDD
backplane and GPU add-on cards. Be sure to connect all these power connectors
to your power supply to ensure adequate power supply to your system. See the
table below for the pin denitions for the 8-pin power connectors.
JPW1: Proprietary main PWR
JPW2: 8-pin Processor PWR
JPW3-JPW7: 8-pin Processor PWR used for HDD BPN/GPU cards
12V 8-pin Power
Connector Pin Denitions
Pins Denition
1 through 4 Ground
5 through 8 +12V