User's Manual (1.0)

Chapter 5: Advanced Serverboard Setup
5-17
Serial Ports
A COM connection (COM1) is located next
to the BMC chip. This port provides serial
port support. See the table on the right for
pin denitions.
Serial Port Pin Denitions
Pin #Denition Pin # Denition
1 DCD 6 DSR
2 RXD 7 RTS
3 TXD 8 CTS
4 DTR 9 RI
5 Ground 10 NC
TPM/Port 80 Header
A Trusted Platform Module/Port 80 header,
located at JTPM1, provides TPM support
and Port 80 connection. Use this header
to enhance system performance and data
security. See the table on the right for pin
denitions.
TPM/Port 80 Header
Pin Denitions
Pin # Denition Pin # Denition
1 LCLK 2 GND
3 LFRAME# 4 <(KEY)>
5 LRESET# 6 +5V (X)
7 LAD 3 8 LAD 2
9 +3.3V 10 LAD1
11 LAD0 12 GND
13 SMB_CLK4 14 SMB_DAT4
15 +3V_DUAL 16 SERIRQ
17 GND 18 CLKRUN# (X)
19 LPCPD# 20 LDRQ# (X)
Standby Power Header
The +5V Standby Power header is located
at JSTBY1 on the motherboard. See the
table on the right for pin denitions. (You
must also have a card with a Standby
Power connector and a cable to use this
feature.)
Standby PWR
Pin Denitions
Pin# Denition
1 +5V Standby
2 Ground
3 No Connection
I/O Connections
COM1
COM2
Video Connection
A video (VGA) port is located next to LAN
ports 0/1 on the rear I/O shield. Refer to the
motherboard layout below for the location.