User's Manual (1.0)

Chapter 5: Advanced Serverboard Setup
5-21
VGA Enable/Disable
JPG1 allows you to enable or disable the
VGA port. The default position is on pins
1 and 2 to enable VGA. See the table on
the right for jumper settings.
VGA Enable/Disable
Jumper Settings
Jumper Setting
Denition
Pins 1-2 Enabled
Pins 2-3 Disabled
Watch Dog Enable/Disable
JWD1 controls the Watch Dog function.
Watch Dog is a system monitor that
can reboot the system when a software
application hangs. Jumping pins 1-2
(default) will cause WD to reset the system
if an application hangs. Jumping pins 2-3
will generate a non-maskable interrupt
signal for the application that hangs. See
the table on the right for jumper settings.
Watch Dog must also be enabled in BIOS.
Note: When enabled, the user must write
their own application software to disable
the Watch Dog Timer.
Watch Dog
Jumper Settings
Jumper Setting Denition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
Manufacturer Mode Select
Close jumper JPME1 to bypass SPI ash
security and force the system to use the
Manufacturer Mode, which allows the user
to ash the system rmware from a host
server to modify system settings. See the
table on the right for jumper settings.
ME Mode Select
Jumper Settings
Jumper Setting Denition
1-2 Normal (Default)
2-3 Manufacture Mode
Power Force-On Enable
Jumpers JPF1/JPF2 are used for power
force on. The default setting is on pins 2-3
for normal operation. See the table on the
right for jumper settings.
Power Force-On
Enable
Jumper Settings
Jumper Denition
1-2 Enabled
2-3 Normal (Default)
BMC Enable/Disable
Jumper Settings
Both Jumpers Denition
Pins 1-2 Enabled
Pins 2-3 Disabled
BMC Enable/Disable
Use jumper JPB1 to enable or disable the
BMC (Baseboard Management Controller),
which supports IPMI 2.0/KVM. See the
table on the right for jumper settings.