User's Manual (1.0)

6-4
SUPERSERVER 2028GR-TR/TRT/TRH/TRHT Series User's Manual
Figure 6-3. Removing a Dummy Drive from the Drive Carrier
Figure 6-4. Proper Installation of the Carrier into the Hard Drive Bay
Installing a Hard Drive into a Drive Carrier
1. Remove the four screws securing the dummy drive to the hard drive carrier.
2. Insert a hard drive into the carrier with the PCB side facing down and the con-
nector end toward the rear of the carrier. Align the hard drive in the hard drive
carrier so that the mounting holes of the carrier are aligned with the mounting
holes of the drive. Note that there are holes in the carrier which are marked
“SATA” to aid in correct installation.
3. Secure the drive to the carrier with four screws. Use the M3 at-head screws
included in the HDD bag of your accessory box. Note: The screws used to
secure the dummy drive to the carrier cannot be used to secure the hard drive.
4. Insert the hard drive and drive carrier into its bay vertically, keeping the carrier
oriented so that the release button is on the bottom. When the carrier reaches
the rear of the drive bay, the handle will retract.
5. Using your thumb, push against the upper part of the hard drive handle. Push
the hard drive into the hard drive bay as illustrated below, until the hard drive
clicks into the locked position.
Dummy Drive
Hard Drive Carrier