User's Manual (1.0)
6-6
SUPERSERVER 2028GR-TR/TRT/TRH/TRHT Series User's Manual
6-4 Installing Graphics (GPU) Cards
The chassis supports up to six GPU cards, which are mounted in brackets to t
into the PCI-Express slots at the front of the chassis. NVIDIA Kepler K10/K20/K40
GPUs are supported. The GPU cards may be preinstalled, the procedure below is
provided if a GPU card must be replaced. See the NVIDIA web site for more details
on the GPU specications.
Installing Graphics Cards
1. Identify the left and right brackets and graphics cards as illustrated.
2. Insert the graphics cards into the brackets, aligning the mounting holes in the
cards with those in the brackets. For Intel Xeon PHI card, a separate custom
bracket, MCP-120-00070-0N, is required.
3. Secure each card to the bracket using the screws that are included for this
purpose.
4. Carefullly position each bracket in the chassis as illustrated, aligning the four
mounting holes in the top and side of each bracket with the corresponding
mounting holes in the chassis. Pay attention to the airow arrows to install each
card into the correct side of the chassis
5. Secure the bracket to the chassis by using the screws provided.
6. After a GPU card is installed, you must connect it to one of the following power
headers on the serverboard: JPW3, JPW4, JPW5, JPW6, JPW7 or JPW8.
Figure 6-5. Installing GPU Cards into the Left and Right GPU Brackets
Left Side GPU Bracket
and Cards
Right Side GPU Bracket
and Cards
1
2
Airow