User's Manual (1.0)

Chapter 6: Advanced Chassis Setup

6-15

6-7 Power Supply

The system includes a dual hot-plug 2000Watt power modules. They automatically

sense the input voltage between 100v to 240v, and operate at that voltage. Note

that different input voltages will result in different maximum power output levels.

In the event of a power supply failure, the remaining power supply will automati-

cally take over. The failed power module can be replaced without powering-down

the system. Replace with the same model. Replacement modules can be ordered

directly from Supermicro.

An amber light on the power supply is illuminated when the power is switched off.

An green light indicates that the power supply is operating.

Replacing the Power Supply

1. Push the release tab on the front of the failed power supply.

2. Grasp the handle of the power supply and pull it out of the power supply bay.

3. Push the new power supply module into the power bay until it clicks into the

locked position.

Figure 6-18. Removing the Power Supply