User's Manual (1.0)

2-8

SUPERSERVER 6017TR-TQF/TFF/TF User's Manual

Figure 2-5. Accessing the Inside of the System

2-6 Checking the Serverboard Setup

After you install the SuperServer 6017TR-TQF/TFF/TF in the rack, you will need

to open the unit to make sure the serverboard is properly installed and all the

connections have been made.

Accessing the inside of the System

Before operating the server for the ﬁ rst time, it is important to remove the protective

ﬁ lm covering the top of the chassis, in order to allow for proper ventilation and

cooling.

Removing the Chassis Cover and Protective Film (Figure 2-5)

1. Disconnect the chassis from any power source and remove all four screws.

2. Gently push down on the chassis cover in the areas indicated in the

illustration.

3. Push the cover toward the rear of the chassis and lift the cover upwards and

off the chassis.

4. Peel off the protective ﬁ lm covering the top cover and the top of the chassis

5. Check that all ventilation openings on the top cover and the top of the chassis

are clear and unobstructed.

Remove this

screw

Remove this

screw

Remove this

screw