User's Manual (1.0)

5-18
SUPERSERVER 6017TR-TQF/TFF/TF User's Manual
5-8 Connector Defi nitions
Power Connectors
Two 20-pin main power supply
connectors (J23/J24) and a 4-pin power
connector (JP8) are located on the
serverboard. These power connectors
meet the SSI EPS 12V specifi cation. For
power supply to work properly, please
follow the instructions given below. See
the table on the right for pin defi nitions.
Note 1: You cannot use both 20-pin power
connectors: PWR1 (the right connector)
and PWR2 (the left connector) as input
power supply at the same time. Only
one connector can be used for input
power supply to the serverboard at a
time. For proper use of these proprietary
PWR Connectors, please customize
your PWR cables based on Supermicro
PWR Connector Pin-Out Definitions
listed above.
Note 2: The black square (dot) on a
power connector indicates the location
of Pin 1.
ATX Power 20-pin Connector
Pin Defi nitions (J23/J24)
Pin# Defi nition Pin# Defi nition
1 GND 11 PS_ON_N
2 GND 12 5V_STBY
3 GND 13 GND
4 GND 14 GND
5 GND 15 GND
6NC 16NC
7 12V 17 12V
8 12V 18 12V
9 12V 19 12V
10 12V 20 12V
4-pin Auxiliary Power Connector
In addition to two 20-pin power
connectors, a 4-pin 12V PWR supply
is located at JP8 on the serverboard.
This power connector is used to provide
power supply to hard drive disks. Refer
to the layout below for the location.
Note1: The 4-pin Auxiliary Power
Connector is used for power supply
output to HDDs only.
Note 2: The black square (dot) on the
power connector indicates the location
of Pin 1.
4-Pin PWR
Pin Defi nitions (JP8)
Pin# Defi nition
1 +12V
2 Ground
3 Ground
4 +5V