User's Manual (1.0)

Chapter 6: Advanced Chassis Setup
6-11
6-9 Expansion Slot Setup
SC808 chassis includes I/O slots for expansion cards. Each side supports one
low profi le, half-length expansion card for a total of two per system (Figure 6-11).
Expansion Card
Slot Clip
Temporary "L" Bracket
Figure 6-11: Expansion Card Placement
Installing Expansion Cards (Figure 6-12)
1. Disconnect the chassis from any power source, lay the chassis on a fl at
surface, and open the chassis cover.
2. Pull open the expansion card slot clip in the rear of the chassis.
3. Slide the temporary expansion card "L" bracket toward the slot clip and
remove the temporary bracket from the chassis.
4. Connect the expansion card to the riser card and slide the expansion card "L"
bracket in to the rear expansion card slot.
5. Close the expansion card slot clip.
6. Close the chassis cover and reconnect the chassis to the power source.
Note: Under normal circumstances, the riser card and expansion card bracket are
not separated.