User's and BIOS Manual (1.0a)

Chapter 5: Advanced Serverboard Setup
5-7
Figure 5-5. Top View of DIMM Slot
Figure 5-4. Side View of DIMM Installation into Slot
To Install: Insert module vertically and press down until it snaps into
place. Pay attention to the bottom notches.
To Remove: Use your thumbs to gently push each release tab
outward to free the module from the slot.
Memory Support
The X6DH8-XG2 supports up to 16 GB of registered ECC DDR2-400
(PC3200) memory. The memory is an interleaved configuration, which re-
quires modules of the same size and speed to be installed in pairs.
Note: You should not mix modules of different sizes and/or speeds.
Note: Notches
should align
with their
receptive points
on the slot
Notch
Notch
Release
Tab
Release
Tab
DIMM2