User's and BIOS Manual (1.0a)

Chapter 5: Advanced Serverboard Setup
5-13
Power Button
The Power Button connection is lo-
cated on pins 1 and 2 of JF1. Mo-
mentarily contacting both pins will
power on/off the system. This button
can also be configured to function as
a suspend button (see the appropri-
ate setting in BIOS). To turn off the
power when set to suspend mode,
depress the button for at least 4 sec-
onds. Refer to the table on the right
for pin definitions.
Pin
Number
1
2
Definition
PW_ON
Ground
Power Button
Connector
Pin Definitions
(JF1)
Universal Serial Bus
There are five USB 2.0 (Universal
Serial Bus) ports/headers on the
serverboard. Two of them are back
panel USB ports (USB0/1) and the
other three are front panel USB
headers (JUSB2 and JUSB3). See
the tables on the right for pin defi-
nitions.
Reset Button
The Reset Button connection is lo-
cated on pins 3 and 4 of JF1. Attach
it to the hardware reset switch on the
computer case. Refer to the table on
the right for pin definitions.
Chassis Intrusion
A Chassis Intrusion header is lo-
cated at JL1. Attach the appropri-
ate cable to inform you of a chas-
sis intrusion.
Pin
Number
3
4
Definition
Reset
Ground
Reset Pin
Definitions
(JF1)
Pin
Number
1
2
Definition
Intrusion Input
Ground
Chassis Intrusion
Pin Definitions (JL1)
Pin# Definition
1 Vcc
2 Data-
3 Data+
4 Ground
Pin
Number
2
4
6
8
10
Definition
Vcc
Data-
Data+
Ground
NA
Pin
Number
1
3
5
7
Definition
Vcc
Data-
Data+
Ground
USB Pin Definitions
(JUSB2, JUSB3)
(USB0/1)
9Key