User's and BIOS Manual (1.0a)

6-2
SUPERSERVER 6034H-X8R Manual
Figure 6-1. Chassis: Front and Rear Views
Mute
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications.
A ribbon cable has bundled these wires together to simplify the connection.
Connect the cable from JF1 on the serverboard to JP4 on the Control Panel PCB
(printed circuit board). Make sure the red wire plugs into pin 1 on both JF1 and
JP4. Pull all excess cabling out of the airflow path. The LEDs inform you of
system status. See "Chapter 3: System Interface" for details on the LEDs and
the control panel buttons. Details on JF1 can be found in the "Chapter 5:
Advanced Serverboard Setup."
Control Panel/
System LEDs
Main Power
Slim-Line
CD-ROM DriveFloppy Drive
SCSI Drives (8) 5.25" Drive Bays
Ethernet Ports
USB Ports
Keyboard/Mouse Ports
COM1 Port
PCI Expansion Slots (6)
VGA Port
Reset
Power Supplies (3)