User's and BIOS Manual (1.0a)

6-4
SUPERSERVER 6034H-X8R Manual
Figure 6-2. System Cooling Fans
6-4 Drive Bay Installation/Removal
Accessing the Drive Bays
SCSI Drives: You do not need to access the inside of the chassis to replace
or swap SCSI drives. Proceed to the next step for instructions.
Note: You must use standard 1" high, 80-pin SCA SCSI drives in the
SuperServer 6034H-X8R.
CD-ROM/Floppy Disk Drive: For installing/removing the CD-ROM or floppy
disk drive, you will need to gain access to the inside of the server by
removing the top cover of the chassis. Proceed to the "CD-ROM and Floppy
Drive Installation" section later in this chapter for instructions.
5.25" Drive Bays: For installing/removing a component in one of the 5.25"
drive bays, proceed to the "5.25" Drive Bay Installation" section later in this
chapter for instructions.