User's and BIOS Manual (1.0a)

Chapter 6: Advanced Chassis Setup
6-7
Installing Components in the 5.25" Drive Bays
1. Mounting the component in the drive carrier
A component such as an IDE hard drive or an additional SCSI drive that
can fit into a standard IDE drive bay can be mounted in a 5.25" drive bay.
The component should also be mounted in a drive carrier to simplify its
installation and removal from the chassis. These carriers also help promote
proper airflow. For this reason, even empty carriers without a component
installed must remain in the chassis. To add a component such as those
noted above, install a drive into the carrier with the printed circuit board side
toward the carrier so that the mounting holes align with those in the carrier.
Secure the drive to the carrier with the four screws.
Figure 6-5. SCSI SCA Backplane
A
D
C
B
BUZZER RESET
FAN#3
JP43
FAN#2
JP42
FAN#1
JP41
SUPER SCA833S
SCSI Backplane Jumper Settings
Location Jumper Description Default Setting
A JP19 Buzzer Reset* Open
B JP41 FAN#1 On/Sense Open
C JP42 FAN#2 On/Sense Open
D JP43 FAN#3 On/Sense Open
*Pressing the mute button on the control panel will disable the buzzer alarm.
You should then press the button once again to re-enable the alarm.