User's and BIOS Manual (1.0a)

6-8
SUPERSERVER 6034H-X8R Manual
2. Installing/removing 5.25" drive bay component
Two 5.25" drive bays are located in the front of the chassis, making them
easily accessible for installation and removal. Components installed in these
bays are not hot-swappable, meaning system power must be turned off before
installing and/or removing them.
To remove the drive carrier, first power down the system and then remove the
top cover of the chassis. Push the latch located at the rear of the drive bay
you wish to remove and then push the drive bay out through the front of the
chassis (see Figure 6-6). Attach the component to the carrier if installing.
Reverse this procedure to install the drive, making sure the latch clicks when
re-inserting the drive bay into the chassis. Replace the top cover when
finished.
Note: The red wire on a ribbon cable typically designates the location of pin 1.
Figure 6-6. Removing a 5.25" Drive Bay