User's and BIOS Manual (1.0a)

Chapter 6: Advanced Chassis Setup
6-9
CD-ROM and Floppy Drive Installation
The top cover of the chassis must be opened to gain access to the CD-ROM
and floppy drive bays. The 6034H-X8R accomodates only slim CD-ROM
drives. Side mounting brakets are typically needed to mount a slim CD-ROM
drive in the 6034H-X8R server.
To remove the CD-ROM or floppy drive carrier, first power down the system and
then remove the top cover of the chassis. Push the latch located at the rear of
the CD-ROM or floppy drive bay and then push the drive bay out through the front
of the chassis. See Figures 6-7 and 6-8 for illustrations of removing these drives.
The illustrations also show how to mount each drive on the rails, which are
needed to slide them into the open chassis bays. Reverse this procedure to re-
install the drives, making sure the latch clicks when re-inserting the drive bay into
the chassis. Replace the top cover when finished.
Note: The red wire on a ribbon cable typically designates the location of pin 1.
Figure 6-7. CD-ROM Drive Installation