Computer Hardware User Manual

Chapter 2: Installation

2-3

Installation Instructions

Install the I/O shield into the chassis.

Caution: To avoid damaging the motherboard and its components, please

do not use a force greater than 8 lb/inch on each mounting screw during

motherboard installation.

Locate the mounting holes on the motherboard. Refer to the layout on the

previous page for mounting hole locations.

Locate the matching mounting holes on the chassis. Install standoffs in the

chassis as needed. Align the mounting holes on the motherboard against the

mounting holes on the chassis.

Install the motherboard into the chassis carefully to avoid damage to mother-

board components.

Insert a Pan head #6 screw into a mounting hole on the motherboard and its

matching mounting hole on the chassis, using the Philips screwdriver.

Repeat Step 4 to insert #6 screws to all mounting holes.

I/O Shield

Stand Off

Make sure that the motherboard is securely placed on the chassis.