User`s manual

SC825 Chassis Manual

5-6

5-5 Installing an Optional Floppy or Fixed Hard Drive

The SC825 chassis models include two open slots for an optional oppy drive,

and/or hard disk drive(s). To utilize these slots, the dummy drive and the slot cover

must be removed.

Removing the Dummy Drive, Floppy Drive or Hard Disk Drive

1. Disconnect the chassis from any power source.

2. Press the release tab.

3. Push against the back of the dummy drive, sliding the dummy drive and slot

cover forward, out through the front of the chassis.

4. Insert the drive into rear of the open slot and connect the wiring.

Figure 5-7: Removing the Dummy Drive and Slot Cover

Release Tabs