SUPERSERVER User's Manual

5-4

UPERSERVER 6015T-T/6015T-INF User's Manual

5-4 I/O Ports

The I/O ports are color coded in conformance with the PC 99 speciﬁ cation. See

Figure 5-2 below for the colors and locations of the various I/O ports.

Figure 5-1. Control Panel Header Pins

Note: Inﬁ niBand ports are included on the X7DBT (6015T-INF) only. To prevent

damage to the port or serverboard, an Inﬁ niBand bracket (included) must be used

to secure the connector to the I/O shield.

LAN1 LAN2

COM2 Port (Turquoise) VGA Port (Blue)USB 0/1 Ports

Figure 5-2. I/O Ports

NMI

x (Key)

Vcc 5V Stby

Vcc 3V

Vcc 3V Stby

Vcc 3V

Reserved

Reset (Button)

Power (Button)

Ground

x (Key)

Power On LED

IDE/SATA LED

NIC1 LED

NIC2 LED

OH/Fan Fail LED

Reserved

Ground

2 1

20 19

Connecting the Control Panel

JF1 contains header pins for various front control panel connectors. See Figure

5-1 for the pin locations of the various front control panel buttons and LED indica-

tors. All JF1 wires have been bundled into a single ribbon cable to simplify this

connection. Make sure the red wire plugs into pin 1 as marked on the board. The

other end connects to the Control Panel PCB board, located just behind the system

status LEDs on the chassis.

Inﬁ niBand Port