User`s manual

7-16
SUPERSERVER 6018R-WTR(T) USER'S MANUAL
ASPM Support
This feature allows the user to set the Active State Power Management (ASPM)
level for a PCI-E device. Select Auto to allow the system BIOS to automatically
set the ASPM level for the system. Select Disabled to disable ASPM support. The
options are Disabled and Auto.
Warning: Enabling ASPM support may cause some PCI-E devices to fail!
Above 4G Decoding (Available if the system supports 64-bit PCI decoding)
Select Enabled to decode a PCI device that supports 64-bit in the space above 4G
Address. The options are Enabled and Disabled.
PCH Slot 2 PCI-E 2.0 x1 OPROM, PCH Slot 3 PCI-E 2.0 x4 (in x8) OPROM, CPU1
Slot 4 PCI-E 3.0 x8 OPROM, CPU1 Slot 6 PCI-E 3.0 x8 OPROM
Select Enabled to enable Option ROM support to boot the computer using a device
installed on a slot specifi ed above. The options are Enabled and Disabled.
Onboard LAN Option ROM Select
Select iSCSI to use the iSCSI Option ROM to boot the computer using a network
device. Select PXE (Preboot Execution Environment) to use an PXE Option ROM
to boot the computer using a network device. The options are iSCSI and PXE.
Load Onboard LAN1 Option ROM/Load Onboard LAN2 Option ROM
Select Enabled to enable the onboard LAN1 Option ROM/LAN2 Option ROM. This
is to boot the computer using a network device. The default setting for LAN1 Option
ROM is Enabled, and the default setting for LAN2 Option ROM is Disabled.
Load Onboard SAS Option ROM
Select Enabled to enable the onboard SAS Option ROM. This is to boot the
computer using a SAS device. The options are Enabled and Disabled.
VGA Priority
This feature allows the user to select the graphics adapter to be used as the primary
boot device. The options are Onboard, and Offboard.
Network Stack
When this featurer is set to Enabled, both PXE (Preboot Execution Environment)
and UEFI (Unifi ed Extensible Firmware Interface) will be enabled for network stack
support. The options are Enabled and Disabled.