User`s manual

7-14

SUPERSERVER 7046T-3R User's Manual

PCI IDE Bus Master

When enabled, the BIOS uses PCI bus mastering for reading/writing to IDE drives.

The options are Disabled and Enabled.

Slot 1 Option ROM~Slot 6 Option ROM

Select Enabled to enable Slot 1 Option ROM~Slot 6 Option ROM, which will allow

you to boot the computer from a PCI device installed on a PCI slot. The options

are Disabled and Enabled.

LAN1 PXE/LAN2 PXE/LAN3 PXE/LAN4 PXE (-LN3 PXE/-LN4 PXE: for LN4

models only)

Select Enabled to enable the onboard LAN1/LAN2 PXE Option ROMs. This is

to boot computers using a network interface. The options are Enabled and Dis-

abled.

XSuper IO Device Conﬁ guration

Onboard Floppy Controller

Select Enable to enable the onboard Floppy Controller. The options are Enabled

and Disabled.

Floppy A/Floppy B

This feature allows the user to select the type of ﬂ oppy drive connected to the sys-

tem as speciﬁ ed. The options are Disabled, 360KB 5 1/4", 1.2MB 5 1/4", 720KB 3

1/2", 1.44MB 3 1/2" and 2.88MB 3 1/2". The default setting for Floppy A is 1.44MB

3 1/2", and for Floppy B is Disabled.

Serial Port1 Address/ Serial Port2 Address

This option speciﬁ es the base I/O port address and the Interrupt Request address

of Serial Port 1 and Serial Port 2. Select Disabled to prevent the serial port from

accessing any system resources. When this option is set to Disabled, the serial port

physically becomes unavailable. Select 3F8/IRQ4 to allow the serial port to use 3F8

as its I/O port address and IRQ 4 for the interrupt address. The options for Serial

Port1 are Disabled, 3F8/IRQ4, 3E8/IRQ4, 2E8/IRQ3. The options for Serial Port2

are Disabled, 2F8/IRQ3, 3E8/IRQ4, and 2E8/IRQ3.

Serial Port 2 Mode

Use this feature to conﬁ gure Serial Port 2 mode. The options are Normal, IrDA

and ASK IR. IrDA (Infrared Data) is an industry standard for remote control de-

vices. ASK IR (Amplitude Shifted Keying Infrared) is a protocol compatible with

Sharp® branded PDAs and other infrared devices.