User`s manual

2-4
S
UPERSERVER 8045C-3R User's Manual
2-4 Installing the System into a Rack
This section provides information on installing the system into a rack unit. Rack
installation requires the use of the optional rackmount kit If the system has already
been mounted into a rack or if you are using it as a tower, you can skip ahead to
Sections 2-5 and 2-6. There are a variety of rack units on the market, which may
mean the assembly procedure will differ slightly. The following is a guideline for
installing the server into a rack with the rack rails provided in the rackmount kit.
You should also refer to the installation instructions that came with the rack unit
you are using.
Rack Rail Sections
The rackmount kit includes two rack rail assemblies. Each of these assemblies
consist of two sections: an inner fi xed chassis rail that secures to the chassis and
an outer rack rail that secures directly to the rack itself. The inner and outer rails
must be detached from each other before installing.
Removing the Inner Rail
To remove the inner chassis rail, pull it out as far as possible - you should
hear a "click" sound as a locking tab emerges from inside the rail assembly
and locks the inner rail.
Depress the locking tab to pull the inner rail completely out. Do this for both
assemblies (one for each side).
1.
2.
Figure 2-1. Inner Fixed Chassis Rail