User`s manual

5-24
S
UPERSERVER 8045C-3R User's Manual
SATA Ports
There are no jumpers to confi g-
ure the onboard SATA connec-
tors. See the table on the right
for pin defi nitions.
SATA Port
Pin Defi nitions (JS1-JS6)
Pin # Defi nition
1 Ground
2TXP
3TXN
4 Ground
5RXN
6RXP
7 Ground
IDE Drive Connectors
Pin Defi nitions (JIDE1/JIDE2)
Pin# Defi nition Pin # Defi nition
1 Reset IDE 2 Ground
3 Host Data 7 4 Host Data 8
5 Host Data 6 6 Host Data 9
7 Host Data 5 8 Host Data 10
9 Host Data 4 10 Host Data 11
11 Host Data 3 12 Host Data 12
13 Host Data 2 14 Host Data 13
15 Host Data 1 16 Host Data 14
17 Host Data 0 18 Host Data 15
19 Ground 20 Key
21 DRQ3 22 Ground
23 I/O Write 24 Ground
25 I/O Read 26 Ground
27 IOCHRDY 28 BALE
29 DACK3 30 Ground
31 IRQ14 32 IOCS16
33 Addr1 34 Ground
35 Addr0 36 Addr2
37 Chip Select 0 38 Chip Select 1
39 Activity 40 Ground
IDE Connectors
There are two IDE Connectors (JIDE1:
Blue, JIDE2: White) on the serverboard.
JIDE1 is designated as the Primary
IDE drive. JIDE2 is designated as the
Secondary IDE drive and is reserved for
Compact Flash Card use only. (See the
note below.) See the table on the right
for pin defi nitions.
Note: JIDE2 (the white slot) is reserved
for Compact Flash Card only. Do not
use it for other devices. If JIDE2 is
populated with a Compact Flash Card,
JIDE1 (the blue slot) will be available for
one device only. For the Compact Flash
Card to work properly, you will need to
connect a power cable to JWF1 fi rst.