User`s manual

X9SRA Motherboard Series User's Manual

B-2

5. When the screen as shown above displays, using the arrow key,

select the item- "Proceed with ash update" and press the <Enter> key.

You will see the progress of BIOS Recovery as shown in the screen

below.

To perform UEFI BIOS recovery using a USB-attached device, follow the instruc-

tions below.

1. Using a different machine, copy the "Super.ROM" binary image le into the

disc Root "\" Directory of a USB device or a writeable CD/DVD.

Note: If you cannot locate the "Super.ROM" le in your driver disk, visit

our website at www.supermicro.com to download the BIOS image into a

USB ash device and rename it to "Super ROM" for BIOS recovery use.

2. Insert the USB device that contains the new BIOS image ("Super.

Rom") into your USB drive and power on the system

3. While powering on the system, keep pressing <Ctrl> and <Home> simultane-

ously on your PS2 or USB keyboard until your hear two short beeps. This

may take from a few seconds to one minute.

4. After locating the new BIOS binary image, the system will enter the BIOS

Recovery page as shown below.

Note: At this point, you may decide if you want to start with BIOS Recovery.

If you decide to proceed with BIOS Recovery, follow the procedures below.

Main Advanced Event Logs IPMI Boot Security Exit

 : Select Screen

 : Select Item

Enter: Select

+/- : Change Opt.

F1 : General Help

F2 : Previous Values

F3 : Optimized Defaults

F4 : Save & Exit

ESC : Exit

WARNING! BIOS Recovery Mode has been detected

Set this to start ash

update

Recovery

Flash Update Parameters

Reset NVRAM

[Enabled]



Proceed with Flash Update