Datasheet

Chapter 1: Introduction
1-3
Processors
The P4SCT+ supports a single Intel® Pentium® 4 processor of up to 3.40
GHz with hyper-threading technology in a 478-pin microPGA socket (must
be 0.09 or 0.13 micron technology) or single a Intel® Celeron® processor of
up to 2.80 GHz. Please refer to the support section of our web site for a
complete listing of supported processors (http://www.supermicro.com/sup-
port/).
Memory
The P4SCT+ has four (4) 184-pin DIMM sockets that can support up to 4 GB
of ECC or non-ECC unbuffered DDR400/333/266 SDRAM modules. (Memory
operates in a dual-channel, or interleaved configuration for increased per-
formance.) Low-profile memory modules are required for use in the 1U
form factor of the 5013C-MT. Module sizes of 128 MB, 256 MB, 512 MB and
1 GB may be used to populate the DIMM slots.
Serial ATA
A Marvell Serial ATA controller is included on the P4SCT+ to provide a four-
port Serial ATA subsystem.
PCI Expansion Slots
The P4SCT+ has two 32-bit, 33 MHz (5V) PCI slots and three 64-bit, 66 MHz
(3.3V) PCI-X slots. When incorporated into the 5013C-MT server system, one 64-
bit, 66 MHz PCI-X slot is available with the use of a riser card, which supports
one full-height, full-length PCI card.
Ethernet Ports
The E7210 includes an on-chip Gb Ethernet controller and the P4SCT+ has an
additional Gb Ethernet controller to support a total of two Gigabit LAN ports.