Datasheet

2-4
SUPERSERVER 5013C-MT User's Manual
2-4 Installing the 5013C-MT into a Rack
This section provides information on installing the SuperServer 5013C-MT into a
rack unit. If the system has already been mounted into a rack, you can skip
ahead to Sections 2-5 and 2-6. There are a variety of rack units on the market,
which may mean the assembly procedure will differ slightly. The following is a
guideline for installing the unit into a rack with the rack rails provided with the
system. You should also refer to the installation instructions that came with the
rack unit you are using.
Identifying the Sections of the Rack Rails
You may have received rack rail hardware with the SuperServer 5013C-MT. (Two
front inner rails should already be attached to the chassis.) This hardware
consists of two rear inner rails that secure to the chassis, one on each side just
behind the preinstalled front inner rails. Note that these two rails are left/right
specific.
Installing the Rear Inner Rails
First, locate the right rear inner rail (the rail that will be used on the right side
of the chassis when you face the front of the chassis). Align the two square holes
on the rail against the hooks on the right side of the chassis. Securely attach
the rail to the chassis with M4 flat head screws. Repeat these steps to install
the left rear inner rail to the left side of the chassis (see Figure 2-1). You will
also need to attach the rail brackets when installing into a telco rack.
Locking Tabs: Both chassis rails have a locking tab, which serves two functions.
The first is to lock the server into place when installed and pushed fully into the
rack, which is its normal position. Secondly, these tabs also lock the server in
place when fully extended from the rack. This prevents the server from coming
completely out of the rack when you pull it out for servicing.