Datasheet

2-10
SUPERSERVER 5013C-MT User's Manual
2-6 Checking the Drive Bay Setup
Next, you should check to make sure the peripheral drives and the Serial
ATA drive and Serial ATA backplane have been properly installed and all
essen-
tial connections have been made.
1. Accessing the drive bays
All drives can be accessed from the front of the server. For servicing
the CD-ROM and floppy drives, you will need to remove the top chassis
cover. The Serial ATA disk drive can be installed and removed from the front
of the chassis without removing the top chassis cover.
2. Installing a CD-ROM and floppy disk drives
Refer to Chapter 6 if you need to reinstall a CD-ROM and/or floppy disk
drive to the system.
3. Check the Serial ATA disk drives
Depending upon your system's configuration, your system may have one
or more Serial ATA drives already installed. If you need to install a Serial
ATA drive, please refer to the appropriate section in Chapter 6.
4. Check the airflow
Airflow is provided by three 4-cm high performance fans. The system compo-
nent layout was carefully designed to promote sufficient airflow through the
small 1U rackmount space. Also note that all power and data cables have
been routed in such a way that they do not block the airflow generated by the
fan.
5. Supplying power to the system
The last thing you must do is to provide input power to the system. Plug
the power cord from the power supply unit into a high-quality power
strip that offers protection from electrical noise and power surges. It is
recommended that you use an uninterruptible power supply (UPS).