Datasheet

5-8
SUPERSERVER 5013C-MT User's Manual
5-7 Adding PCI Cards
1. 64-bit PCI-X slot
The 5013C-MT comes with a riser card that supports one standard size 64-bit,
66 MHz PCI-X (3.3V) card. This riser card allows a single PCI-X card to sit at
a 90 degree angle so it can fit inside the chassis.
2. PCI card installation
The system should be powered down when adding or removing PCI
cards. Begin by removing the top cover of the chassis. You will see a
metal enclosure that houses the riser card. Remove this housing by
lifting the two plastic levers at either end and pulling the housing up and
out of the chassis. The riser card is attached to the inside top of the
housing. Release the latch that secures the PCI slot shield to the housing
by pulling it away from the housing. Remove the shield and insert a PCI-
X card into the slot on the riser card, pushing down with your thumbs
evenly on both sides of the card. After the card has been added, push
the latch back into position. Replace the housing in the serverboard
making sure the plastic levers properly catch on the chassis, then push
them down to lock the housing in place. Finish by replacing the top
chassis cover and powering up the system.
Note: The PCI slot shields protect the serverboard and its components
from EMI and aid in proper ventilation, so make sure there is always a shield
covering the slot.
Figure 5-6. Top View of DIMM Slot