Datasheet

6-2
SUPERSERVER 5013C-MT User's Manual
Figure 6-2. Chassis Rear View
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the motherboard to provide you with system control buttons
and status indicators. These wires have been bundled together in a ribbon cable
to simplify the connection. Connect the cable from JF1 on the motherboard to
JP4 on the Control Panel PCB (printed circuit board). Make sure the red wire
plugs into pin 1 on both JF1 and JP4. Pull all excess cabling out of the airflow
path. The LEDs inform you of system status. See Chapter 3 for details on the
LEDs and the control panel buttons. Details on JF1 can be found in Chapter 5.
Figure 6-1. Chassis Front View