Datasheet

Chapter 6: Advanced Chassis Setup

6-7

6-5 Power Supply

The SuperServer 5013C-MT has a single 300 watt power supply. This power

supply has the capability of operating at 100 or 240 input volts. Depress the main

power button on the front of the chassis and then unplug the AC power cord to

completely remove power from the system before removing the power supply.

Power Supply Failure

If the power supply unit fails, the system will shut down and you will need to

replace the power supply unit. Replacement units can be ordered directly from

Supermicro (PWS-0054 - see contact infomation in Chapter 1).

Replacing the Power Supply

1. Accessing the inside of the SuperServer 5013C-MT

To replace a power supply, you must first remove the top chassis cover.

To do so, first release the retention screws that secure the unit to the

rack. Grasp the two handles on either side and pull the unit straight out

until it locks (you will hear a "click"). Next, depress the two buttons on

the top of the chassis to release the top cover and push it away from

you. You can then lift the top cover from the chassis to gain full access

to the inside of the server.

2. Removing the power supply

First unplug the power cord from the system. To remove the failed

power unit, remove the two screws on the back of the power supply,

which secure it to the chassis. You can then lift the unit straight out of

the chassis. (The power cord should have already been removed.)

3. Installing a new power supply

Replace the failed unit with another unit of the same wattage. It is highly

recommended to replace it with the exact same power supply. Carefully

insert the new unit into position in the chassis and secure it with the two

screws at the rear of the unit. Before reconnecting the power cord,

make sure the power switch on the power supply is in the off position.

Then reconnect the power cord, replace the chassis top cover and push

the unit back into the rack. Finish by turning the power switch on the

power supply on, and then depress the power button on the front of the

system.