User`s manual

Chapter 6: Advanced Chassis Setup
6-13
6-9 Power Supply
The SC732 chassis includes a 500 Watt power supply. In the event that it becomes
necessary to replace the power supply, follow the instructions below.
Changing the Power Supply
1. Disconnect the chassis from any power source.
2. Disconnect the serverboard cables.
3. Remove the screws securing the power supply to the chassis, which are
located on the rear of the chassis. Set these screws aside for later use.
4. Gently lift the power supply out of the chassis.
5. Replace the failed power supply with an identical power supply model.
6. Secure the new power supply using the screws previously set aside.
7. Plug the AC power cord back into the module and power-up the system.
Figure 6-12. Removing the Power Supply
Power Supply