User Manual

Chapter 5: Advanced Motherboard Setup
5-25
USB Wake Up
Use jumper JPUSB to activate the
"wake-up" function of the USB ports
by pressing a key on a USB keyboard
or clicking the USB mouse connected.
This jumper is used together with a
USB Wake-Up feature in the BIOS.
Enable this jumper and the USB
support in the BIOS to wake up your
system via USB devices.
Note: Use JPUSB1 for the USB ports
on the back panel.
USB Wake-Up
Jumper Settings (JPUSB1)
Jumper Setting Defi nition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
Manufacturing Mode
Close Pin 2 and Pin 3 of Jumper
JPME2 to bypass SPI flash security
and force the system to operate in
Manufacturing Mode, allowing the
user to flash the system firmware
from a host system for system setting
modifications. See the table on the
right for jumper settings.
Manufacture Mode (JPME2)
Jumper Settings
Pin# Defi nition
1-2 Normal (Default)
2-3 Manufacture Mode
Over-Clock Management Buttons
Press these buttons to activate and
manage the over-clocking feature
of the motherboard. These buttons
will allow the CPU to run above its
rated speed. This is an advanced
feature and should only be used by
experienced users. Refer to the table
on `the right for a description of each
button.
Over-Clocking Buttons
Switch Settings
Switch Setting Defi nition
S10 On Memory Overclock (Set in BIOS)
S5 On 15% Over-Clock
S6 On 20-25% Over-Clock
S7 On User Defi ned (Set in BIOS)
S9 Reset to Default (No Over-Clock)
VGA Enable/Disable
Close Pin 2 and Pin 3 of jumper
JPG1 to disable the onboard graphics
device. See the table on the right for
jumper settings.
VGA Enable/Disable
Jumper Settings (JPG1)
Pin# Defi nition
1-2 Normal (Default)
2-3 VGA Disabled